Overview: 

This PM02 Analog Power Module provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection.


Specifications:

  • • Input Voltage: 2S-12S
  • • PCB Cont. Current Rating: 60A
  • • PCB Burst Current Rating: 100A (<60 Sec
  • • Max Current Sensing: 120A
  • • Output: DC 5.2V & 3A Max
  • • Voltage Divider: 18.182
  • • Amperes per Volt: 36.364
  • • Weight: 20g

 

Please Note:

The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. 

PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D).

 

Package Includes:

  • - 1x Power Module with XT60 Connectors Board (pre-soldered)
  • - 1x Electrolytic capacito: 220uF 63V (pre-soldered)
  • - 1x Molex 6 Position Connector 15 cm
  • - 1x JST GH 6 Position Connector 15 cm

 

Translation missing: en.general.search.loading